Couldn't load pickup availability
Looking for a replacement part for your Uncommon Telescoping Flagpole? The large bushing fits between the bottom two sections of your flagpole.
- Inside diameter measures 2-1/4".
- Outside diameter measures 2-3/8".
- View letter E in the replacement parts diagram for the large bushing.
Most orders ship within 1 business day. Please allow 7 to 10 days for delivery on some of the International and Historic flags as well as some Specialty and State flags. Shipments on orders received after 1pm may be delayed until the next business day.
Most orders ship via USPS Priority or Speedee for local deliveries. UPS or FedEx shipping is available upon request; however, additional fees will apply to orders shipped via UPS or FedEx. We do not ship to destinations outside the United States. We will email the tracking number once order is processed.
You may return any item for any reason within 30 days of receipt for a refund, exchange, or credit. During the holidays, items purchased between November 1st and December 31st can be returned until January 31st. Shipping, handling, and all other fees are not refundable.
Please contact us immediately if your item did not arrive in perfect condition or if we sent you the wrong item.
Why Fly Me Flag
⭐Fast Shipping - most orders ship within 24 hours
⭐American Flags Made in the USA
⭐Safe Secure Checkout w/ SSL Encryption
⭐35 Years of Experience: Trust the Flag Authorities
⭐We Have Your Back & Stand Behind Our Products
Questions & AnswersAsk a Question
How do you install these bushings without breaking them?
To replace the bushings on your Uncommon Telescoping Flagpole: 1.) Lower the flagpole sections and remove it from the ground sleeve. 2.) Remove any ornaments from the top of the flagpole (gold ball, eagle, solar light, etc.). 3.) Remove the screws from the top stop ring (located below the top harness). This will allow you to lower the top stop ring and top harness so you can access the top ornament fitting into which the gold ball was threaded. 4.) Gently tap upward on the rim of the top ornament fitting with a rubber mallet until it is free from the flagpole. 5.) Slide the stop ring and remaining harnesses off the top of the flagpole. 6.) At the bottom of the flagpole, remove the screw(s) from the bottom cup; then, remove the bottom cup from the flagpole by gently shaking it up and down. 7.) Slide the large section over the top of the remaining sections and replace the largest bushing. 8.) To replace bushings on the remaining sections, continue using this process: 8a.) Drill out the rivets at the bottom of the section(s) using a #30, 1/8" drill bit. 8b.) To remove the plunger housing, first remove the screw(s) from either side of the plunger pin. Then, push the plunger housing out of the bottom of the section by holding the pin in with one hand. At the same time, take a small screwdriver and push in the tab on each side of the section so the plunger becomes off-set. Finally, gently shake the flagpole up and down to remove the plunger housing. 9.) Now, the section will slide over the top of the remaining section(s) and the bushing can be accessed and replaced.